Difference between revisions of "Reddy Update"
From IntRoLab
(→Cabling Improvements) |
(→Documents) |
||
Line 87: | Line 87: | ||
= Documents = | = Documents = | ||
+ | [[File:MotorControllerTuningWin32.zip]] |
Revision as of 14:13, 28 July 2009
Contents
Schedule
Week 31, July 27 - August 1 |
|
Week 32, August 3 - August 9 |
|
Week 33, August 10 - August 15 |
|
Arm Improvements
To have better control of the arm (and neck) motors, we did the following :
- Change the Motor PCB to support
- Temperature detector. A signal will be sent to the motor controller if the motor temperature is higher than 60 degrees celcius. Analog temperature value is also available.
- Potentiometer feedback.
- Motor power connection.
- Design a new PCB with support to 4 motors
- Communicate with the CAN bus already available on Reddy
- Allow position feedback from the RS-232 interface
- Create a tuning GUI for easier setup of the robot controllers
Motor PCB
Motor Controllers
- A new motor drive that can connect up to 4 motors have been designed.
- A new adjustable bracket for fixing the drive to the side of the robot have been designed.
- We installed two motor controllers (one on each side) to allow the modification of 8 motors. Motors modified are :
- Arm-elbow (x2)
- Arm-shoulder (x2)
- Arm-updown (x2)
- Neck-YES (x1)
- Neck-NO (x1)
Cabling Improvements
- Cables are now better organized
- Added connectors inside the arm to disconnect motors easily for repairs
- Signals are color coded as follow (TODO ADD DOCUMENTATION)
- Red
- Green
- Black
- Yellow
- Purple
- Gray
- White
- Blue
Head Improvements
File:ReddyGravityCompensation.jpg
Motor controllers for head movement (YES-NO)
- Same motor controllers were used for the neck to add overheating protection and better feedback / control
Tuning the motor controller
A GUI was created to facilitate motor tuning.
RS-232 protocol enhancements
CAN command added
Future Improvements
- Single 12V power supply could be useful for direct connection to Pioneer robots. A 12V-->8.5V DC-DC (100W) converter is required for this operation. This item can be ordered at Vicor. 8.5V batteries would then be useless.